VINCENT SA-93 PLUS Instructions For Use Manual page 25

MAIN AMPLIFIER CONNECTION
You can choose between symmetrical (using RCA connectors) or unsymmetrical (using XLR connectors)
interconnection of your pre- and power-amplifiers. Up to four main amplifier channels can be connected.
So more than two loudspeakers can be supplied or two speakers can be used biwiring or biamping them.
Choose the appropriate setup for your system:
UNSYMMETRICAL CONNECTION
Unsymmetrical connection of one or
more main amplifiers
With all equipment switched off, connect the RCA
cables to the pre-amplifier outputs marked with
„1" in the „output" terminal and on the other side
of the cable(s) to the main amplifier RCA inputs
Connection
one Amplifier
Symmetrical connection of two main
amplifier channels
Connect two XLR cables to the pre-amplifier outputs
marked with „balanced" in the „output" terminal
and on the other side of the cables with the main
amplifier XLR inputs (often marked as „Input",
„Balanced IN" oder „Power Amp IN"). Make sure
to not interchange right and left channels.
Letters „R" and „L" show you the assignments.
1 2 BALANCE
OUTPUT
BALANCE LINE4
INP UT PUT
SYMMETRICAL CONNECTION
(often marked as „Input" oder „Power Amp In").
Make sure to not interchange right and left chan-
nels. Letters „R" and „L" show you the assignment.
When connecting four amplifier channels additio-
nally use the pre-amplifier outputs marked with
„2" in the same way.
Connection
two Amplifiers
L
1 2 BALANCE
OUTPUT
BALANCE LINE4 L
IN PUT PUT
BALANCE LINE4 L
IN PUT PUT
1 2 BALANCE
OUTPUT
BALANCE LINE4 L
IN PU T PUT
Vincent
25