Remote Control - VINCENT SA-93 PLUS Instructions For Use Manual

Stereo control amplifier
Hide thumbs Also See for SA-93 PLUS:
Table of Contents

Advertisement

Available languages

Available languages

Point the diode side of the remote set to the front
panel of the pre-amplifier, make sure there are no
objects between the remote set and the device.
Keep the distance between remote set and device
less than 7 meters. Do not point from an angle
greater than 30 degrees from the middle axis.
Change the batteries when the distance of reliab-
le operation is shortening.
Incorrect handling of the batteries can cause acid
leakage or in extreme cases explosion.
The cells must be inserted respecting the correct
polarity as seen on the plan inside the battery
housing.
For longlife operation do not mix old batteries and
new ones and use the same battery type (for exam-
ple alcaline).
Some battery cells are rechargable, some are not.
Refer to the details written on the cell surface.
Remove batteries when not using the remote
control for an extended period. Used batteries are
hazardous waste and must be disposed of accor-
ding to local regulations. Do not put them into
household waste.
Use only micro AAA cells (LR3)
Vincent
22

REMOTE CONTROL

BATTERIES
Changing of batteries:
1. Open the metal cover on the backside of the
remote. The cover plate is being held magne-
tically, a little pull from underneath the notch
in the case of the remote set will do.
2. Remove used cells and insert new ones as
seen on the scheme inside.
3. Close the cover.
1
Old
New
2
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sa-93plus

Table of Contents