Table of Contents
Advertisement
The Setup Command
Entering the Setup Command
From the SCE# prompt, type
Step 1
The following dialog appears:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' followed by 'Enter' for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
system configuration dialog begins.
Defining Lists in the Setup Utility
Multiple entry parameters (Lists)
When explicitly invoked, the setup utility offers the option of multiple entries (lists) for certain
parameters.
Several parameters, such as the Access Control Lists, are actually lists containing several entries. If these
lists are empty (initial configuration) or contain only one entry, they act the same as any scalar parameter,
except that you are given the option of adding additional entries to the list.
If these lists already contain more than one entry, the entire list is displayed, and you are then presented
with several options. Following is an excerpt from the SNMP trap manager menu, illustrating how to
configure list entries.
The entries in the list are displayed.
Step 1
There are 2 SNMP trap managers in the current configuration as follows:
IP address: 10.10.10.10 Community: privateVersion: 1
IP address: 10.11.10.1 Community: pcubeVersion: 2c
Three options are presented.
Step 2
If only one entry exists in the table, it is displayed as the default [ ] to be either accepted or changed. The
Note
three list options are not displayed.
Please choose one of the following options:
1. Leave the running configuration unchanged.
2. Clear the existing lists and configure new ones.
3. Add new entries.
Enter your choice:
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
4-4
and press Enter.
setup
Chapter 4
Utilities
OL-7827-12
Advertisement
Table of Contents
