Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
How to Disable the SNTP Multicast Client
From the SCE(config)# prompt, type no sntp broadcast client and press Enter.
Step 1
Disables the SNTP multicast client. It will not accept any broadcast time updates.
How to Enable the SNTP Unicast Client
•
•
Options
The following option is available:
•
Step 1
From the SCE(config)# prompt, type sntp server ip-address and press Enter
Defines the SNTP unicast server so that SNTP client is able to query that server.
Enabling SNTP Unicast Client: Example
The following example shows how to enable an SNTP server at IP address 128.182.58.100.
SCE(config)# sntp server 128.182.58.100
How to Disable the SNTP Unicast Client
•
•
How to Disable the SNTP Unicast Client and Remove All Servers
Step 1
From the SCE(config)# prompt, type no sntp server all and press Enter.
Removes all SNTP unicast servers, preventing unicast SNTP query.
OL-7827-12
Options, page 5-65
Enabling SNTP Unicast Client: Example, page 5-65
ip-address — the IP address of the SNTP unicast server.
How to Disable the SNTP Unicast Client and Remove All Servers, page 5-65
How to Remove One SNTP Server, page 5-66
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configure SNTP
5-65
Advertisement
Table of Contents
