Configuring The Physical Ports; Cli Help Features; Partial Help - Cisco SCE2020-4XGBE-SM Configuration Manual

Chapter 2 Command Line Interface

Configuring the Physical Ports

The SCE platform contains the following physical port interfaces:
•
•

CLI Help Features

CLI provides context sensitive help. Two types of context sensitive help are supported:
•
•

Partial Help

To obtain a list of commands that begin with a particular character string, enter the abbreviated command
entry immediately followed by a question mark (?). This form of help is called partial help, because it
lists only the keywords or arguments that begin with the abbreviation you entered.
Example:
The following example illustrates how typing c? displays all available arguments that start with the letter
c.
SCE(config)#snmp-server c?
Community contact
SCE(config)#snmp-server c
OL-7827-12
Management:
The following commands are used to configure the management port:
ip address
–
– duplex
– speed
– active-port
auto-fail-over
–
Gigabit Ethernet
The following commands are used to configure the Gigabit Ethernet line ports. These are the
commands for which the range interface mode is relevant; use the range interface command to
configure more than one interface at a time if you are configuring them to identical values.
– auto-negotiate
– bandwidth
– queue
Partial Help, page 2-9
Argument Help, page 2-10
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
CLI Help Features
2-9