Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Configuring AAA Accounting
Use this command to enable or disable TACACS+ accounting.
•
•
•
If TACACS+ accounting is enabled, the SCE platform sends an accounting message to the TACACS+
server after every command execution. The accounting message is logged in the TACACS+ server for
the use of the network administrator.
By default, TACACS+ accounting is disabled.
Options
The following options are available:
•
How to Enable AAA Accounting
Step 1
From the SCE(config)# prompt, type aaa authentication accounting commands level default
stop-start group TACACS+ and press Enter.
The start-stop keyword (required) indicates that the accounting message is sent at the beginning and
the end (if the command was successfully executed) of the execution of a CLI command.
How to Disable AAA Accounting
From the SCE(config)# prompt, type aaa authentication accounting commands level
Step 1
press Enter.
Monitoring TACACS+ Servers
Use these commands to display statistics for the TACACS+ servers.
•
•
How to Display Statistics for TACACS+ Servers
From the SCE# prompt, type show TACACS and press Enter.
Step 1
OL-7827-12
Options, page 5-25
How to Enable AAA Accounting, page 5-25
How to Disable AAA Accounting, page 5-25
level — The privilege level for which to enable the TACACS+ accounting
How to Display Statistics for TACACS+ Servers, page 5-25
How to Display Statistics, Keys and Timeouts for TACACS+ Servers, page 5-26
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring the Available Interfaces
default
5-25
and
Advertisement
Table of Contents
