Table of Contents
Advertisement
Configuring Dynamic Mapping of RDRs to Categories
How to Configuring Mappings
Use these command to add or remove a mapping.
Options
The following options are available:
•
•
How to Add a Mapping to a Category
Step 1
From the SCE(config)# prompt, type
category-number
If the table already contains a mapping with the same tag and category number, an error is issued and
nothing is done.
How to Remove a Mapping from a Category
From the SCE(config)# prompt, type
Step 1
category-number
How to Restore the Default Mapping for a Specified RDR Tag
From the SCE(config)# prompt, type
Step 1
press Enter.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
8-16
tag-umber — The complete 32 bit value given as an hexadecimal number. The RDR tag must be
already configured in the Formatter by the application.
category-number — Number of the category (1-4) to which to map the RDR tag.
category-number
category-number
Chapter 8
Raw Data Formatting: The RDR Formatter and NetFlow Exporting
rdr-formatter rdr-mapping (tag-id
and press Enter.
)
no rdr-formatter rdr-mapping (tag-id
and press Enter.
)
default rdr-formatter rdr-mapping tag-id
tag-number
tag-number
tag-number and
OL-7827-12
Advertisement
Table of Contents
