Before Using; Cautions On Installation; Dvd Surround Receiver; Speaker System And Subwoofer - Denon S-301 Operating Instructions Manual

Denon dvd home theater system operating instructions s-301
Hide thumbs Also See for S-301:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
Getting Started

Before using

Pay attention to the following before using this unit:
• Handle the power supply cord carefully
Do not damage or deform the power supply
cord. If it is damaged or deformed, it may
cause electric shock or malfunction when
used. When removing from wall outlet, be
sure to remove by holding the plug
attachment and not by pulling the cord.
• Do not open the top cover
In order to prevent electric shock, do not open
the top cover.
• Do not place anything inside
Do not place metal objects or spill liquid inside
the DVD surround receiver.
Electric shock or malfunction may result.
• Moving the set
To prevent short circuits or damaged wires in
the connection cables, always unplug the
power supply cord and disconnect the
connection cables between all other audio
components when moving the set.
NOTE:
• This DVD surround receiver uses the semiconductor laser. To allow you to enjoy music at a
stable operation, it is recommended to use this in a room of 5 °C (41 °F) ~ 35 °C (95 °F).
Copyrights
• It is prohibited by law to reproduce, broadcast, rent or play discs in public without the consent
of the copyright holder.
Please, record and retain the Model name and serial number of your set shown on the rating label.
Model name : S-301
Serial No.
• Before turning the power switch on
Check once again that all connections are
proper and that there are not problems with
the connection cables. Always set the power
switch to the standby position before
connecting and disconnecting connection
cables.
• Store this instruction in a safe place
After reading, store these instructions along in
a safe place.
• Note
that
the
illustrations
in
instruction may differ from the actual set
for explanation purposes.

Cautions on installation

DVD Surround receiver

Noise or disturbance of the picture may be
generated if this unit or any other electronic
equipment using microprocessors is used near
a tuner or TV.
If this happens, take the following steps:
• Install this unit as far as possible from the
tuner or TV.
• Set the antenna wires from the tuner or TV
away from this unit's power supply cord and
input/output connection cords.
this
• Noise
or
disturbance
tends
particularly when using indoor antennas or
300
/ohms feeder wires. We recommend
using outdoor antennas and 75
coaxial cables.
Note:
For heat dispersal, do not install this
equipment in a confined space such as a
book case or similar unit.
Note
3
ENGLISH

Speaker system and subwoofer

The quality of the sound produced from the
speaker system is affected by the size and type
of the room, as well as by the method of
installation. Consider the points listed below
before installing the speaker system.
• Note that placing the speaker system on the
same stand or shelf as a record player may
result in howling.
• If there is a wall, glass door, etc., directly in
front of or behind the speaker system, cover
to
occur
the wall or door with a thick curtain to prevent
resonance and reflection.
• The speaker systems are of the low-leakage-
/ohms
flux type and can be used near televisions, but
depending on the TV there may be color
blotching on the picture. If this happens, turn off
the TV's power, move the TV and speaker
system a little apart, wait 15 to 30 minutes,
then turn the TV's power back on. The TV's
automatic degaussing circuit should reduce the
blotching on the picture. If blotching persists,
move the speaker and TV further away from
each other.
• Install on a firm, flat floor to prevent accidents
due to toppling down.
• Do not place a record player, CD player or
other AV components on top of the
subwoofer.
Wall
Getting Started
Wall

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents