Setting "Channel Level - Denon S-301 Operating Instructions Manual

ENGLISH
System Setup

Setting "CHANNEL LEVEL"

• Adjust so that the playback levels of the different channels are
equal.
• Make this adjustment by listening to the test tones output from
the speakers at the listening position.
Use the VOLUME control knob on the main unit or the VOLUME
buttons on the remote control unit to adjust the volume of the
test tone to a level at which it is easy to make this adjustment.
1
CURSOR •
Press the or
"SPEAKER SETUP" at the "AUDIO SETUP",
ENTER
then press the button.
• The "SPEAKER SETUP" screen appears.
2
Press the
"CHANNEL LEVEL", then press the
button.
• The channel level setting screen appears.
ª
button to select
3
Press the
"AUTO", "MANUAL" or "OFF" for the
"TEST TONE" mode, then press the
button.
AUTO:
Adjust the levels listening to test tones automatically output
from the different speakers.
MANUAL:
Select the speakers from which the test tones are output
when adjusting the levels.
OFF (Factory default):
The test tones are not output.
Detailed settings can be made when this is set to
"MANUAL" first.
CURSOR •
or ª button to select
ENTER
CURSOR
0 or 1 button to select
ENTER
53
ENGLISH
4
When "AUTO" mode is selected:
CURSOR
Press the 0 or 1 button to adjust all
-1 the speakers to the same volume.
• Test tones are automatically output from the speakers at
intervals of 4 seconds for two of the cycles shown
below, then at intervals of 2 seconds from the third
cycle on.
Front left
Subwoofer
The level changes in units of 1 dB each time the
CURSOR or button is pressed.
0 0 1 1
The level can be adjusted in the range –12 dB to +12
dB.
4 When "MANUAL" or "OFF" mode is selected:
CURSOR •
ª
Press the or button to select the
CURSOR
speaker, then press the
-2
to adjust all the speakers to the same volume.
5
ENTER
Press the button twice.
• The "SPEAKER SETUP" screen appears.
6
CURSOR ª
Press the button to select "SETUP
ENTER
MENU", then press the
• The "AUDIO SETUP" screen appears.
7
CURSOR ª
Press the button to select "NEXT
SETUP MENU", then press the
the setting.
• The next screen in the "SETUP" menu screen appears.
• When the channel levels are adjusted at the channel level
settings, the adjusted values are applied to all playback modes.
System Setup
Front right
0 or 1 button
button.
ENTER
to enter