Table Of Contents; Before Using; Cautions On Installation; Cautions On Handling - Denon DHT-1000DV Operating Instructions Manual

INTRODUCTION
2
Thank you for choosing the DENON DHT-1000DV Home Theater System. This remarkable component has been engineered to provide
superb surround sound listening with home theater sources such as DVD, as well as providing outstanding high fidelity reproduction
of your favorite music sources.
As this product is provided with an immense array of features, we recommend that before you begin hookup and operation that
you review the contents of this manual before proceeding.

TABLE OF CONTENTS

z
Before Using .....................................................................3
x
Cautions on Installation.....................................................3
c
Cautions on Handling ....................................................3, 4
v
Features ............................................................................4
b
Discs .................................................................................5
n
Cautions on Handling Discs ..............................................5
m
Connections..................................................................6~9
,
Part Names and Functions..............................................10
.
Remote Control Unit .................................................11, 12
⁄0
Setting up the System..............................................13~17
⁄1
Play Back ..................................................................17~19
⁄2
Operation ..................................................................19, 20
ACCESSORIES
2
2 ADV-1000 (Main unit)
Check that the following parts are included in addition to the main unit:
q Operating instructions.....1 w Service station list............................................1
r R6P/AA batteries.............2 t AM loop antenna..............................................1
y FM indoor antenna..........1 u Video cord........................................................ 1
e r
2 USYS-1000 (speaker unit pack)
Before using, check that the package contains the main speaker units (4 units of the USC-A1000 (2 pairs), 1 USC-C1000
and 1 USW-1000) and the accessories shown below.
q Speaker cord A...................................................2
(Used to connect the USC-A1000)
Length: Approx. 10 meters
e Foot...................................................................24
q w
⁄3
Dolby / DTS Surround ...............................................21, 22
⁄4
Surround Playback ....................................................22~26
⁄5
DSP Surround Simulation .........................................26~28
⁄6
Listening to the Radio...............................................28, 29
⁄7
On-Screen Display ..........................................................30
⁄8
Using the On-Screen Display....................................30~37
⁄9
Using the Timer ........................................................37~39
¤0
Changing the Default Settings (DVD) .......................40~45
¤1
Last Function Memory....................................................45
¤2
Initialization of the Microprocessor .................................45
¤3
Troubleshooting...............................................................46
¤4
Specifications ..................................................................47
e Remote control unit
(RC-902)..........................1
t y u
w Speaker cord B........................................................4
(Used to connect the USC-A1000, USC-C1000 and
USW-1000)
Length: Approx. 3 meters
e
1

BEFORE USING

Pay attention to the following before using this unit:
• Moving the set
To prevent short circuits or damaged wires in the
connection cords, always unplug the power cord and
disconnect the connection cords between all other audio
components when moving the set.
• Before turning the power switch on
Check once again that all connections are proper and that
there are not problems with the connection cords. Always
set the power switch to the standby position before
connecting and disconnecting connection cords.
2

CAUTIONS ON INSTALLATION

Noise or disturbance of the picture may be generated if this
unit or any other electronic equipment using microprocessors
is used near a tuner or TV.
If this happens, take the following steps:
• Install this unit as far as possible from the tuner or TV.
• Set the antenna wires from the tuner or TV away from this
unit's power cord and input/output connection cords.
• Noise or disturbance tends to occur particularly when using
indoor antennas or 300 /ohms feeder wires. We
recommend using outdoor antennas and 75 /ohms
coaxial cables.
For heat dispersal, leave at least 10 cm of space between
the top, back and sides of this unit and the wall or
other components.
3

CAUTIONS ON HANDLING

• Switching the input function when input jacks are not
connected
A clicking noise may be produced if the input function is
switched when nothing is connected to the input jacks. If
this happens, either turn down the MASTER VOLUME
control or connect components to the input jacks.
• Muting of PRE OUT jacks, HEADPHONE jack and
SPEAKER terminals
The PRE OUT jacks, HEADPHONE jacks and SPEAKER
terminals include a muting circuit. Because of this, the
output signals are greatly reduced for several seconds after
the power switch is turned on or input function, surround
mode or any other-set-up is changed. If the volume is turned
up during this time, the output will be very high after the
muting circuit stops functioning. Always wait until the
muting circuit turns off before adjusting the volume.
ENGLISH
• Store this instructions in a safe place.
After reading, store this instructions along with the warranty
in a safe place.
• Note that the illustrations in this instructions may differ
from the actual set for explanation purposes.
10 cm or more
DIG AUTO
DVD DIGITAL
10 cm or more
• Whenever the power switch is in the STANDBY state,
the apparatus is still connected on AC line voltage.
Please be sure to unplug the cord when you leave home
for, say, a vacation.
Wall
3