Status Byte 3; Status Byte 4; Status Byte 5; Status Byte 6 - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

August 24, 2004

Status byte 3

Status byte 4

Status byte 5

| |
| |

Status byte 6

Bit Description
0 (LSB) Memory sector is full.
1 Home error.
2 Document error. The document was not inserted after the document station
was selected, and the wait subsequently timed out.
3 Flash EPROM load error or MCT load error.
4 Reserved. Always equals 0.
5 User flash storage sector is full.
6 Firmware error. CRC on the firmware failed. The printer is running out of the
boot sector. Only system commands and firmware commands are accepted.
7 (MSB) Command complete ("Erase flash EPROM sector" on page 121, "Flip check" on
page 160, and whenever a physical line is printed). Set to 1 when the
command is complete or a physical line is printed.
Contains the printer engineering code (EC) level with all status messages.
Bit Description
0 (LSB) Printer ID Request/Extended Address command. Set to 1 when responding to a
Printer ID request.
1 EC Level. Set to 1 when responding to an EC level request.
2 MICR Read. Set to 1 when responding to a MICR read command.
3 MCT Read. Set to 1 when responding to an MCT read command.
4 User flash read. Set to 1 when responding to a flash read command.
5 Reserved. Defaults to 1.
6 Scan Complete. Set to 1 when scan completed successfully.
Set to 1 when responding to a "Retrieve scanned image" command.
7 (MSB)
Contains the current line count.
Appendix C. RS-232 programming information
167