August 24, 2004
Installing fillers for USB printers
1. Disconnect the power brick from the printer, if one is connected.
2. Place the display filler appropriate for the video display on the system unit. Do
3. If you have a short keyboard, place the keyboard filler beside the keyboard. See
4. Place the printer filler beside the display filler. Make sure you route the
not remove the knockout section unless you have an integrated video mount.
See Figure 14 on page 28.
Figure 14 on page 28.
keyboard cable to the side, as shown in Figure 14 on page 28.
Chapter 2. Installation instructions
27