Impact Code Page; Proportional Font Example - IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

August 24, 2004
0000111100000000
0001111110000000
0011111111000000
0111000011100000
0110000001100000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1111111111110000
1111111111110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
1100000000110000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
0000000000000000
Figure 46. Proportional Font Example

Impact code page

You define the character matrix for each code page with MCT #4 for impact code
page 1 and MCT #5 for impact code page 2. See Table 13 on page 123.
If the matrix defines the characters as 9 dots high or less, a print line will be printed
in one pass of the printhead. When the matrix is defined as greater than 9 dots
high, it takes two passes of the printhead per print line.
Landscape printing is limited to characters with a height of 9 dots or less. If
user-defined characters are to be used in landscape print mode, they must be less
than 10 dots high.
This command specifies a character width of 12 dots (X'0C') and a
character height of 22 dots (X'16'). Following the width and height are 64
bytes that define the character. If, as in this case, the character is defined
before all 64 bytes have been used, the rest of the bytes are filled with X'0'
(see Figure 46).
Note: If wb were set to 03, then the total number of data bytes would be
98 (3×32+2)
row #
0F00 1
1F80 2
3FC0 3
70E0 4
6060 5
C030 6
C030 7
C030 8
C030 9
C030 10
C030 11
C030 12
FFF0 13
FFF0 14
C030 15
C030 16
C030 17
C030 18
C030 19
C030 20
C030 21
C030 22
0000 23
0000 24
0000 25
0000 26
0000 27
0000 28
0000 29
0000 30
0000 31
0000 32
Appendix C. RS-232 programming information
119