Remote Control Unit Operations; Main Remote Control Unit; Operating Denon Audio Components; Presetting - Denon AVR-3808CI Owner's Manual

Remote Control Unit Operations

Main Remote Control Unit

• On the main remote control unit, the display switches
according to the device being operated and the mode.
• In modes other than iPod, the mode switches between
"DEVICE1" and "DEVICE2" each time the [MODE
SELECTOR] is pressed.
• In the AMP , TUNER, NET/DTU and iPod modes, when
the remote ID is set, the AVR-3808CI can be used
independently even in an environment containing multiple
DENON amplifiers.
Signal transmission
indicator
[ AMP]
[MODE SELECTOR]
[HOME]
[NUMBER]
[RC SETUP]
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
NOTE
The device mode ("DEVICE1" or "DEVICE2") cannot be changed
while the setting is being made.


Operating DENON Audio Components

1
[MODE SELECTOR]
Press for the component to be
operated.
The indicator for the component to be operated flashes.
: AMP / ZONE2 / ZONE3 / : iPod
ZONE4 z / SYSTEM CALL
: DVD player (Recorder) /
: TUNER (FM/AM) / XM
CD player (Recorder)
: NETWORK/USB /
: VCR / TAPE
DIGITAL TUNER z
: TV
: Satellite Receiver / Cable TV
z The AVR-3808CI cannot be used in the ZONE4 or NET/DTU
(DEVICE2) modes.
b The mode switches each time [AMP] is pressed.
GAMP modeG GZONE2 modeG
GSYSTEM CALL modeG GZONE4 modeG
2
Operate the component.
b For details, refer to the component's operating instructions.
HOME
[ ] is used to return to the AMP mode (AMP , ZONE2, ZONE3,
ZONE4 or SYSTEM CALL) when in any mode other than AMP .

Presetting

The included main remote control unit can be preset to
operate devices of various brands.
1
[MODE SELECTOR]
Press
preset.
2
Press and hold in
The signal transmission indicator flashes twice.
3
[NUMBER]
Press
GZONE3 modeG brand of the component to be preset. The numbers
are shown in the Preset Code Table (v End of the
this manual).
When the code is registered, the signal transmission indicator
flashes twice.
When the preset code is transmitted, the mode indicator for the
component to which that code belongs flashes.
b The input mode is canceled if no button is operated for 10
seconds.
Some brands have more than one preset code. If the component does
not operate, try inputting a different code.

Operating Preset Components

1
[MODE SELECTOR]
Press
operated.
The mode indicator of the device to be operated flashes.
2
Operate the component.
b For details, refer to the component's operating instructions.
for the device you want to
[RC SETUP]
for at least 3 seconds.
and input the 5-digit number of the
for the component to be