Checking The Xm Signal Strength And Radio; Searching Categories; Accessing Xm Radio Stations Directly - Denon AVR-3808CI Owner's Manual

<SOURCE SELECT>
uiop
<ON/STANDBY> ENTER <STATUS>
[ TU]
(DEVICE2
mode)
[f]
ENTER
uiop
[SEARCH]
[SAT TU]
(AMP mode)
[NUMBER]
(Main remote control unit)
[ ] [
2
[ ] [
8
[REPEAT]
[RANDOM]
(Sub remote control unit)
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit

Checking the XM Signal Strength and
Radio ID
1
Either turn
(AMP mode) to select "XM".
2
<STATUS>
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
GOOD
MARGINAL
WEAK
NO
[ iPod]
[8],
3
Adjust the position of the antenna until "SIGNAL:
[9],
GOOD" is shown on the display.
[6],
4
[7], <STATUS>
Press
[1], [2] (example: "XM001") is displayed.
[ENTER]
5
[f]
Press and select channel 0 (XM000).
[uiop]
The radio ID is shown on the display.
[SEARCH]
[CHANNEL
+/–]
[iPod]
(AMP mode)
The strength of both the XM satellite and terrestrial signals can be
checked at GUI menu "Source Select" – "XM" – "Antenna Aiming"
(vpage 40).
/ ]
1 3

Searching Categories

]
9
1
Press o p
2
Use o p to select the category, then use
the desired station.
<SOURCE SELECT> [SAT TU]
or press
until "SIGNAL" appears on the
GUI Status
Signal strength is good
Signal strength is marginal
Signal strength is weak
No signal
until the station you want to check
Radio ID
.
Channel category
ui to select

Accessing XM Radio Stations Directly

1
[SEARCH]
Press .
2
[NUMBER]
Press then input the station's channel.
Example: Accessing station "XM123":
[1] → [2] → [3]
b If no button is pressed within several seconds, the station
automatically switches to the one whose number has been input.
3
ENTER
Press to set that station.
Reception switches to the selected station.
• "LOADING" is displayed while stations or data are being received.
• "UPDATING" is displayed while the encoding code is being
updated.
• "XM - - -" is displayed if the selected channel cannot be used.