Remote Control Unit Operations; Main Remote Control Unit (Rc-1099); Presetting; Operating Preset Components - Denon AVR-2309CI Owner's Manual

ENGLISH
Remote Control Unit Operations
I
Main Remote Control Unit
(RC-1099)
[Front]
[SOURCE _--"'---"":-lr'~' [SOURCE
CONTROL 1] ~~ CONTROL 2]
[Rear]
[ZONE2 OFF]
II
9mn_n~1
[MAIN ONI
:GJGJGJ:
[NUMBER]
~GJ
GJ
0!
i,Q.0_8.i
i,G),:
Depending on the model and year of manufacture of your equipment.
some buttons may not operate.
65
o
erating DENON Audio Com onents
1
Set
[SOURCE CONTROL 1]
to "AUDIO".
--------_._------------
•.
_-_.
-
2
Set
[SOURCE CONTROL 2]
to the position for the
component to be operated (CD, iPodlNETWORK or
TUNER).
3
Operate the audio component.
' *
For details, refer to the component's operating instructions.
' *
While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.
Presetting
• DENON and other makes of components can be operated by
setting the preset memory.
• Operation is not possible for some models.
1
Set
[SOURCE CONTROL 1]
to "AUDIO" or ''VIDEO''.
' *
Set to the AUDIO side for the CD position, and to the VIDEO side
for the DVDNDP, VCR, SAT/CABLE or TV position.
2
Set
[SOURCE CONTROL 2]
to the component to be
registered.
3
Press
[ZONE2 OFF]
and
[MAIN ON]
at the same time.
The indicator starts flashing.
4
Press
[NUMBER]
and input the 3·digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (iGT'End of this
manual).
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset
memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: DVDNDP and SAT/CABLE.
II
Operating Preset Components II
1
Set
[SOURCE CONTROL 1]
to "AUDIO" or "VIDEO".
' *
Set to the AUDIO side for the CD position, and to the VIDEO side
for the DVDNDP, VCR, SAT/CABLE or TV position.
2
Set
[SOURCE CONTROl2]
to the component you want
to operate.
3
Operate the component.
' *
For details, refer to the component's operating instructions.
' *
Some models cannot be operated with this remote control unit.