Adjusting The Tone (Tone Control); Making The Multeq, Dynamic Eq And Dynamic Volume Settings (Audyssey Settings) - Denon AVR-590 Owner's Manual

ENGLISH
Setting items
Front Height ON : Use the front height channel.
OFF : Do not use the front height channel.
Set whether or not to use
the front height channel.
This can also be set by pressing
Subwoofer ON : The subwoofer is used.
OFF : The subwoofer is not used.
Turn subwoofer output on
and off.
Default Yes : Reset to the defaults.
Restores all the surround No : Do not reset to the defaults.
parameter settings to their
defaults.

Adjusting the tone (Tone Control)

Setting items
Tone Control ON : Allow tone adjustment (treble, bass).
OFF : Playback without tone adjustment.
Sets the tone control function
ON and OFF.
The tone cannot be adjusted when in the DIRECT mode.
This can be set when
"Dynamic EQ" (vpage
42) is set to "OFF".
Bass –6dB ~ +6dB (0dB)
Adjusts the low frequencies.
This can be set when
"Tone Control" is set to
"ON".
Treble
–6dB ~ +6dB (0dB)
Adjusts the high
frequencies.
This can be set when
"Tone Control" is set to
"ON".
Remote control

operation buttons
Setting contents
.
Default settings are underlined.
Setting contents
Displaying the menu
: Moves the cursor (Up/Down/Left/Right)
:
Cancel the menu
Making the MultEQ, Dynamic EQ and Dynamic Volume
settings (Audyssey Settings)
• When the "Audyssey Auto Setup" (vpage 19) procedure is performed, the "MultEQ" , "Dynamic
EQ" and "Dynamic Volume" functions are enabled.
• Operating conditions for each function
• Dynamic EQ :
When "MultEQ" is set to "ON"
• Dynamic Volume :
When "Dynamic EQ" is set to "ON"
• Setting :
When "Dynamic Volume" is set to "ON"
NOTE
If the speaker settings are changed after the "Audyssey Auto Setup" procedure is performed,
"MultEQ" , "Dynamic EQ" and "Dynamic Volume" functions cannot be selected and "Run Audyssey"
is displayed.
If this happens, either perform the "Audyssey Auto Setup" procedure again, or perform the "Restore"
operation (vpage 23) to restore the settings to as they were after the "Audyssey Auto Setup"
procedure was performed.
Setting items
MultEQ Audyssey : Optimize frequency response of all speakers.
Audyssey Byp.L/R : Optimize frequency response of speakers except
Corrects the frequency
front L and R speakers.
response of the different
speakers. Audyssey Flat : Optimize frequency response of all speakers to flat
response.
NOTE
Manual : Apply frequency response set with "Manual EQ" (vpage 42).
• " MultEQ" and "Manual
OFF : The "MultEQ" equalizer cannot be used.
EQ" settings for which
• W hen "Audyssey" , "Audyssey Byp. L/R" or "Audyssey Flat" is
"Not Used" has been set at
"EQ Customize" (vpage
selected, "
28) cannot be selected.
• A fter running Audyssey Auto Setup, if the Speaker Configuration,
• When using headphones,
Distance, Channel Level, and Crossover Frequency have changed
"MultEQ" is set to "OFF" .
without increasing the number of speakers measured, only "
lights.
• This can also be set by pressing
: Decision the setting
Adjusting the Sound Field Effect (Parameter)
Default settings are underlined.
MultEQ
Dynamic EQ
Dynamic Volume
Setting
Setting contents
" lights.
.
: Return to previous menu
"