Operating The Connected Devices By Remote Control Unit; Registering Preset Codes; Operating Registered Devices - Denon AVR-590 Owner's Manual

Operating the Connected Devices by Remote Control Unit

Registering Preset Codes

DENON and other makes of components can be operated by
setting the preset memory.
n Cautions during operation
When registering a preset code, point the remote control transmitter
toward the AVR-590. The status of the registration operation is
displayed on the AVR-590.
1
Press the source select button (see
below) for the device to be registered
and simultaneously for over 2
seconds.
"RC SETUP START" appears on the display
and the remote control unit is set to the
preset code registration mode.
: TV : Digital video recorder
DVD player
:
: Video deck
or CD player
Satellite receiver
:
: Blu-ray disc player
or cable TV
2
Press ~ and input the
3-digit number of the brand of
the component to be preset. The
numbers are shown in the Preset
Code Table (vEnd of this
manual).
When registration is completed, "RC SETUP OK" appears on
the display.
b
If the codes could not be registered, "RC SETUP NG" appears on
the display. Try again.
3
To store the codes of another component in the
memory, repeat steps 1 to 2.
b
For details, refer to the component's operating instructions.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: DVD/CD and SAT/CBL.

Operating Registered Devices

1
Switch to the device to be operated.
TUNER/AMP
: To operate a Tuner
DEVICE
: To operate a Blu-ray disc player, DVD player,
CD player, Digital video recorder, Video deck,
iPod, Satellite receiver or cable TV
MAIN/TV
: To operate a TV
2
When "DEVICE" has been selected in step 1, press
the source select button for the device to be operated.
The remote control unit is set to the device mode for the device
to be operated. When the remote control transmitter is pointed
towards the AVR-590 at this time, the AVR-590's input source
switches simultaneously.
b The remote control unit stays in the same device mode until a
different source select button is pressed.
3
Operate the component.
b For details, refer to the component's operating instructions.
NOTE
Depending on the model and year of manufacture, this function cannot
be used for some models, even if they are of makes listed in the list
of preset codes.
Operating Registered Devices
iPod
Operation
mode setting
ON/SOURCE
1
2
3
MEMORY
Calling out the top menus z 1
TOP MENU
6 7
(fast-reverse / fast-forward)
8 9
uio p
ENTER
Press and
SEARCH
Browse/Remote
mode switching
RETURN
PAGE d f
z 1 : This operation is possible when using a
DENON ASD-3N or ASD-3W Control Dock
for iPod.
z 2 : This operation is possible when using a
DENON ASD-1R or ASD-11R Control Dock
for iPod.
ENGLISH
Power on / Standby z 1
Play / Pause
Stop
Pause
MEMORY z 1
Manual search
Auto search
(cue)
Cursor
Enter
Once
hold
Page search
mode switching
z 2
Return
Page up/down z 1