Denon AVR-590 Owner's Manual page 28

ENGLISH
Setting items
Speaker Config. Surround : Set the presence and size of the Surround speakers.
• Large : Use of a large speaker that can adequately play back low
Select speaker configuration
frequencies.
and size.
• Small
(bass reproduction capability)
low frequencies.
• None : Select when the surround speakers are not connected.
"Large" is not displayed when "Front" is set to "Small".
S.Back (Pre out) : Set the presence, size and number of surround back
"S.Back" is displayed
speakers.
when the "Pre Assign"
• Large : Use of a large speaker that can adequately play back low
setting (vpage 24) is
frequencies.
set to "Normal" .
• Small : Use of a small speaker that has inadequate playback capacity for
low frequencies.
None : Select when the surround back speakers are not connected.
•
2ch : Use two surround back speakers.
•
• 1ch : Use only one surround back speaker. Surround back audio is output
from the SURR. BACK / FRONT HEIGHT PRE OUT "L" connector.
• " Large" is not displayed when "Surround" is set to "Small".
• Even if "S.Back" is set to "Large" , the "S.Back" setting is automatically
switched to "Small" if "Surround" is set to "Small" .
NOTE
Even when the Surround Back Speaker setting is other than "None" ,
sound may not be emitted from the surround back speaker, depending
on the playback source. In this case, "Surround Back" setting other
than "OFF" (vpage 40).
"Front Height" is
Front Height (Pre out) : Set the front height speaker size.
displayed when the "Pre
• Large : Use of a large speaker that can adequately play back low
Assign" setting (vpage
frequencies.
24) is set to "Front
• Small : Use of a small speaker that has inadequate playback capacity for
Height" .
low frequencies.
• None : Select when a front height speaker is not connected.
NOTE
• "Large" is not displayed when "Front" is set to "Small".
Select "Large" or "Small" not
• Even if "Front Height" is set to "Large", the "Front Height" setting
according to the physical size
is automatically switched to "Small" if "Front" is set to "Small".
of the speaker but according
to the low frequency
reproduction capabilities
based on the frequency set
at "Crossover Frequency"
(vpage 26).
Remote control

operation buttons
Setting contents
: Use of a small speaker that has inadequate playback capacity for
Displaying the menu
:
Cancel the menu
Setting items
Bass Setting
Make the settings related to
playback of low frequency
signals (subwoofer and LFE).
This can be set when
"Speaker Config. "
"Subwoofer" (vpage
24) is set to "Yes" .
Distance
Set the distance from the
listening position to
speakers.
Measure the distance from
the listening position to the
speakers beforehand.
: Moves the cursor (Up/Down/Left/Right)
Making detailed settings (Manual Setup)
Setting contents
Subwoofer Mode : Select low range signal to be reproduced by
subwoofer.
L FE : Add the low frequency signal of the channel for which the speaker
•
size is set to "Small" to the subwoofer signal and output it.
• LFE+Main : Add the low frequency signal of all channels to the subwoofer
signal and output it.
–
• Play music or a movie source and select the mode offering the
strongest bass.
• Select "LFE+Main" if you want the bass signals to always be
produced from the subwoofer.
LPF for LFE : Set the upper limit of the low frequency signals output from
the subwoofer.
8 0Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
•
Unit : Set the unit of distance.
F eet
•
M eters
the •
Step : Set the minimum variable width of the distance.
1 ft / 0.1ft
•
•
0.1m / 0.01m
• FL (Front L)/ FR (Front R)/ C (Center)/ SW (Subwoofer)/ SL (Surround L)/
SR (Surround R/ SBL (Surr. Back L)/ SBR (Surr. Back R)/ FHL (Front Height L)/
FHR (Front Height R) : Select the speaker you want to set, and set the
distance. Set the value that is closest to the measured distance.
• 0.0ft ~ 60.0ft / 0.00m ~ 18.00m
• The speakers that can be selected differ depending on the "Pre Assign"
(vpage 24) and "Speaker Config. " settings.
• Default settings :
Front/Center/Subwoofer/Front Height : 3.6 meters (12 feet)
Surround/Surr. Back : 3.0 meters (10 feet)
NOTE
Set the difference in the distance between the speakers to less than 6.0
meters (20 feet). "Relocate Speaker" is displayed on the screen if an
inappropriate distance is set.
Default : Reset all distance settings to factory default.
Y es : Reset to the defaults.
•
• No : Do not reset to the defaults.
: Return to previous menu
: Decision the setting