In order to run the Dual FX algorithms, the software must be loaded into the PCM
80's "extension" memory. To do this:
If the PCM 80 is turned off:
1.
Insert the Dual FX algorithm card into the PC card slot.
2.
Power up the PCM 80. The software will be loaded automatically.
If the PCM 80 is already running:
1.
Insert the Dual FX algorithm card into the PC card slot.
2.
Press Control and use SELECT and Up and Down to go to Control 2.1.
The following message should appear:
Card Load: Dual FX 1.0
2.1 (Press LOAD)
3.
Press Load/ . The following message will appear briefly to indicate the
load was completed:
Extensions now
available
If the PCM 80 is running an algorithm from a different extension card:
Loading a different algorithm card requires returning to the PCM 80's internal
memory by loading a preset or register from one of the internal banks.
Otherwise, the following error message will be displayed when you press
Load/ :
Cannot load while
running extension
To load a different algorithm card :
1.
Press Program Banks and select an internal preset bank (P0 - P3).
2.
Turn SELECT to display any preset in any of these banks, then press
Load/ .
3.
The new algorithm card can now be loaded as described above.
Dual FX Card Operation
Loading the Dual FX
Algorithms
Once extension card soft-
ware is loaded, you can re-
move the card from the slot.
The algorithms will remain in
the PCM 80 until the unit is
turned off, or a new algorithm
card is loaded. This makes
the PC card slot available for
loading and storing registers
on RAM cards.
1-3