Cueing Programs - Lexicon MPX 200 - REV 2 Manual

MPX 200
The compressor is always available in any program,
situated in front of any other effects in the wet
component signal path. If compression is used
in the loaded program, the appropriate
COMPRESSOR LED will light. The compressor
can always be turned on or off with the Compressor
button. The EFFECTS display shows what would run if
that program were loaded.

CUEING PROGRAMS

For performing live or mixing in the studio, it is
sometimes desirable to "jump" from one program to
another. The MPX 200 allows programs to be cued for
loading.
To cue a program for loading:
1. Turn the Adjust knob to select the desired Program
(but do not press the Load button).
After 4 seconds, the display and the EFFECTS and
ROUTING (DUAL) LEDs will revert to showing the
currently running program, but the Load button will
remain lit to indicate its armed status. To review the
cued program, rotate the Adjust knob one click to
redisplay its number and effects.
2. Press Load to load the cued program.
The Load button lights when a new program has
been selected for loading, indicating that the button
is armed. Pressing the Load button will load the
selected program. (If the selected program has not
been changed or the running program has not been
edited since it was loaded, the LED will not be lit,
indicating that pressing this button will have no
effect.)
Basic Operation
2-3