Table of Contents
Advertisement
Software Version 1.1 Installation Instructions & Release Notes
CONTENTS
This upgrade kit includes one of each of the following:
•
MPX G2 Software Version 1.1 ROM
•
Extractor tool
•
Anti-static wrist strap
•
MPX G2 Software Version 1.1 Installation Instructions &
Release Notes (this document)
This kit does not include a Phillips Head screwdriver,
which is needed to remove the two screws on the rear
panel and the three screws on each side of the unit.
These screws are Lexicon Part Number 640-10498.
PRESERVING USER BANK PROGRAMS &
SYSTEM SETTINGS
User Bank programs will be preserved during the
software installation process. But, to avoid accidental
initialization of User Bank programs and other system
settings, it is recommended to dump system information
to an external MIDI storage device before installing the
new software. To do this, refer to the instructions that
begin at the top of the next column.
6
If desired, follow the instructions that begin below to
perform MIDI dumps of system information and User
Bank programs:
1. Connect a 5-pin MIDI cable from the MPX G2 to an
external MIDI storage device. This cable should be
connected from the MIDI OUT connector on the
MPX G2 to the MIDI IN connector on the external
MIDI device.
2. Press the front panel System button to enable
System Mode. The front panel display will appear as
shown in the figure below.
3. Rotate the front panel selection knob two clicks to
the right, until the MIDI option is selected as shown
in the figure at the top of the next page. The
selection knob is located to the right of the Effect
buttons.
Lexicon
Advertisement
Table of Contents
