Table of Contents
Advertisement
Program Descriptions
PRESET 117
This preset supplies reverb while preserving stereo
imaging in a live stage setup.
preserved with time delay rather than conventional
left/right panning, so a proper channel mix is maintained
in both left and right speakers. To use this program,
observe the following:
•
Use the MPX 200 in-line between mixer and house
amps, not as an effect that is mixed back into the
main left and right signals.
•
On your mixer, pan the input channel for each
musician fully to that musician's side of the stage.
•
Keep the Mix parameter set to 50%, the default
setting when the System Mode parameter Global
Mix Mode is set to Program (Pro).
•
Adjust the reverb level by setting the Balance param-
eter between full left (-50) and about -10. (Typical
values should be between -45 and -40.)
4-18
•
Stereo imaging is
Set the Width parameter for the distance between
the speakers at each side of the stage. The program
loads with an assumed width of approximately 20
feet. The available Adjust knob range is 10 to 50 feet.
These
values
assume
members are seated within 30 degrees of either side
of the stage centerline. The Adjust setting can be
increased if many audience members are seated
further to the sides of the stage, but otherwise it
should be kept as low as possible.
Lexicon
that
most
audience
Advertisement
Chapters
Table of Contents
