Lexicon MPX 200 - REV 2 Manual page 36

System Mode
The MPX 200 provides ultimate control with its System
Mode parameters. System Mode can be used to change
the behavior of the MPX 200, as well as access its
internal MIDI dumps and features.
To enter System Mode, press and hold Bypass
for approximately 2 seconds. The Bypass LED
lights and the display flashes "SyS" to indicate
that System Mode is active. When "SyS" stops
flashing, the display will read "Out" for Output Level, the
first System Mode parameter.
Note:
In System Mode, all other front panel controls are
disabled until System Mode is deactivated.
However, the MPX 200 is still able to pass and
process audio while in this mode.
System Mode parameters available in this mode are
shown in the table on the next page. To select a
parameter, press Bypass. Each press of the Bypass button
will advance to the next available parameter. A symbolic
3-character string will appear on the digital display to
3-2
indicate which parameter is selected. When the last
parameter is selected, the next press of the Bypass
button returns to the Output Level parameter. (This
behavior is similar to that of the Edit parameters.)
To view the current setting of the selected parameter,
turn the Adjust knob one click. The display will show the
current setting. To change a parameter setting, turn the
Adjust knob further (either left or right). (In some
instances, such as MIDI dumps, the Store LED lights.
Press Store to execute the dump. The display will
indicate the current state.)
Note:
System Mode parameter settings are automatically
saved. Changes made to these parameters are
applied immediately (except Global Compressor
Mode), and retained until settings are changed
again.
To exit System Mode, press and hold Bypass
again for approximately 2 seconds. The display
will flash "Sto" to verify that changes have been stored.
Lexicon