Table of Contents
Advertisement
Understanding printer menus
Menu item
Portrait Width
3–17 inches
76–432 mm
Portrait Height
3–17 inches
76–432 mm
Feed Direction
Short Edge
Long Edge
Bin Setup menu
Menu Item
Output Bin
Standard Bin
Bin <x>
Description
Sets the portrait width
Notes:
•
If the width exceeds the maximum, the printer uses the maximum
width allowed.
•
11.69 inches is the US factory default setting. Inches can be
increased in 0.01‑inch increments.
•
297 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Sets the portrait height
Notes:
•
If the height exceeds the maximum, the printer uses the maximum
height allowed.
•
17 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
•
432 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Specifies the feed direction if the paper can be loaded in either direction
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
maximum width supported in the tray.
Description
Specifies the default output bin
Note: Standard Bin is the factory default setting.
141
Advertisement
Table of Contents
