Ricoh Aficio MP 2500 Network Manual page 95

❖ Configuration
msh> wiconfig "parameter"
Parameter
mode [ap|adhoc|802.11adhoc]
ssid "ID value"
channel frequency "channel no."
key [ "key value" ] val [1|2|3|4]
Remote Maintenance by telnet
Value configured
You can set the infrastructure mode(ap) , the
802.11 Ad hoc mode (802.11adhoc), or the ad
hoc mode (adhoc).
The default is ad hoc mode.
You can make settings for the SSID in the in-
frastructure mode.
Usable characters are ASCII 0x20-0x7e (32 bytes).
An SSID value is set automatically to the
nearest access point if no setting is made.
If no setting is made for the 802.11 ad hoc
mode, the same values for the infrastructure
mode or an ASSID value is automatically set.
The default is blank.
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key. The default is "11".
You can specify the WEP key when entering
in hexadecimal.
With a 64-bit WEP, you can use 10 digit hex-
adecimals. With a 128-bit WEP, you can use
26 digit hexadecimal.
Up to four WEP keys can be registered. Spec-
ify the number to be registered with "val".
When a WEP is specified by key, the WEP
specified by key phrase is overwritten.
To use this function, set the same key
number and WEP key for all ports that trans-
mit data to each other. Put "0x"on the front
of WEP key.
You can omit the numbers with "val". The
key number is set to 1 when making these
omissions. The default is blank.
2
87