Ricoh Aficio MP 2500 Network Manual page 84

Monitoring and Configuring the Printer
msh> set rfu
msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
2
msh> set bonjour
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
❖ Configuration
• Enter "up"to enable protocol, and enter "down" to disable protocol.
You can set the protocol to "active" or "inactive".
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot use remote access after logging off. If you
did this by mistake, you can use the control panel to enable remote access
via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http,
bonjour, and sftp.
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot use remote access after logging off. If you
did this by mistake, you can use the control panel to enable remote access
via IPv6.
• Disabling IPv6 also disables lpr6, ftp6, rsh6, diprint6, ssl6, ipp6, http6, and
sftp6.
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set lpr {up | down}
msh> set lpr6 {up | down}
msh> set ftp {up | down}
msh> set ftp6 {up | down}
msh> set rsh {up | down}
msh> set rsh6 {up | down}
msh> set diprint {up | down}
msh> set diprint6 {up | down}
msh> set web {up | down}
76