Ricoh Aficio MP 2500 Network Manual page 116

Monitoring and Configuring the Printer
Message
Attach FileServer= <file servername>
Attach to print queue <print queue name>
authenticating
2
authentication mode mismatch
Authentication mode mismatch< SSID >
btd is disabled.
cipher suite mismatch
centrod is disabled.
Cannot create service connection
Cannot find rprinter (<print server
name>/<printer number>)
Change IP address from DHCP Server.
Client password rejected
Client tls certificate rejected
Connected DHCP Server(<DHCP server ad-
dress>).
Could not attach to File Server<error number> (In the remote printer mode) Connection to the
108
Problem and solutions
Connection to the file server as the nearest
server has been established.
(In the print server mode) Attached to the
print queue.
The computer is performing WPA authentica-
tion through the access point.
The authentication modes of the computer and
access point do not match.
Authentication mode is different to the AP.
The required SSID is the SSID of the access
point connected to when in infrastructure
mode.
Communication via Bluetooth is unavailable
because btd is disabled in the security mode.
Enable the btd in the security mode.
The cipher suite (TKIP/AES/WEP) of the
computer and that of the access point do not
match.
Communication via parallel connections una-
vailable because centrod is disabled in the se-
curity mode.
Enable centrod in the security mode.
(In the remote printer mode) Connection to the
file server has not been established. The
number of file server users may have exceeded
the maximum capacity of the file server.
The printer with the number displayed on the
print server does not exist. Make sure that the
printer number is registered on the print serv-
er.
The IP address changes when DHCP lease is
renewed. To always assign the same IP ad-
dress, set a static IP address to the DHCP serv-
er.
The client's password was rejected. Check the
client password.
The client's TLS certificate was rejected. Check
the certificate.
The IP address was successfully received from
the DHCP server.
file server has not been established. The file
server has refused the connection. Check the
file server configuration.