Ricoh Aficio MP 2500 Network Manual page 118

Monitoring and Configuring the Printer
Message
Interface (interface name): Duplicate IP Ad-
dress (IP address).
< Interface >: Subnet overlap.
IPP cancel-job: permission denied.
2
IPP job canceled. jobid=%d.
LEAP challenge to access point failed
LeaseTime=<lease time>(sec), Renew-
Time=<renewtime>(sec).
Login to fileserver <file server name>
(<IPX|IPv4|IPv6>,<NDS|BINDERY>)
Memory allocate error.
MIC failure TKIP counter measures started
MIC failure TKIP counter measures stopped
Name registration success. WINS Serv-
er=<WINS server address> NetBIOS
Name=<NetBIOS name>
Name registration success in Broadcast
name=<NetBIOS Name>
Name registration failed. name=<NetBIOS
name>
nbtd start.
no RADIUS/authentication server
no smart card detected on device
nprinter start (Netware)
nwstart start. (NetWare)
Open log file <file name>
Print queue <print queue name> cannot be
serviced by printer 0, <print server name>
110
Problem and solutions
The same IP (IPv4 or IPv6) address was used.
Each IP address must be unique. Check the ad-
dress of the device indicated in [IP address].
The same IP address (IPv, orIPv6 address) and
the subnet mask is used with other device.
The printer could not authenticate the name of
the user attempting to cancel a job.
The spooled job was canceled due to error or
user request.
LEAP authentication has failed.
The resource lease time received from the
DHCP server is displayed in [lease time] in
seconds. The renewal time is displayed in [re-
new time] in seconds.
(In the print server mode) Login to the file
server is in the NDS or BINDERY mode.
Data cannot be obtained.
Disconnect the USB cable, and then connect it.
An attack was detected during TKIP operation
and the computer has taken countermeasures.
Following attack during TKIP operation, the
computer has ended attack countermeasures
after 60 seconds.
Name registration of <NetBIOS Name> to
<WINS server address> was successful.
Name registration by Broadcast name of <Net-
BIOS Name> was successful.
Name registration of <NetBIOSName> failed.
Change to different NetBIOS name.
The nbtd service has started.
A RADIUS server could not be found.
No smartcard was detected on the computer
during GTC authentication.
(In the remote printer mode) The NetWare
service has started.
The service for NetWare protocol stack setting
has started.
(In the print server mode)The specified log file
has been opened.
(In the print server mode) The print queue
cannot be established. Make sure that print
queue exists on the specified file server.