Setup Troubleshooting; Incorrect Language Appears On The Display - Lexmark 13R0245 - X6575 USB 2.0/PictBridge/ 802.11g All-in-One Color Printer Scanner Copier Fax Photo Setup Manual

Troubleshooting
If you set up your printer on a wireless network, make sure:
•
The wireless network is working properly.
•
The computer and printer are both connected to the same wireless network.
•
The printer is within the range of the wireless network. The effective range for optimal performance is generally
100–150 feet.
•
The printer is located away from other electronic devices that may interfere with the wireless signal.
•
The power supply is connected to the printer, and
•
The Wi-Fi indicator light is green.
•
The printer driver is installed on the computer from which you are performing a task.
•
The correct printer port is selected.

Setup Troubleshooting

Incorrect language appears on the display

These are possible solutions. Try one of the following:
Change the language selection during initial setup
After you select a language, Language appears again on the display. To change the selection:
1
Press or repeatedly until the language you want appears on the display.
2
Press to save.
Select a different language after initial setup
1
From the control panel, press Settings.
2
Press or repeatedly until Device Setup appears.
3
Press .
4
Press or repeatedly until Language appears.
5
Press .
6
Press or repeatedly until the language you want appears on the display.
7
Press .
8
Press or until Yes appears.
9
Press to save.
Note: If you cannot understand the language on the display, see "Resetting the printer to factory default settings"
on page 172.
is lit.
137