Programs Supplied On The Cd; System Requirements; Installing Software; Uninstalling Software - Ricoh 3200SF - Multifunctional SP Network-Ready User Manual

2
Programs supplied on
the CD
The CD-ROM supplied with your printer card provides you with:
• SetIP: A utility program allowing you to select a network
printer card and manually configure the addresses for use
with the TCP/IP protocol.

System requirements

To install SetIP, the following are required:
• Operating system: Windows 2000/XP/2003
• Computer/Processor: 133 MHz or faster Pentium-compatible
processor
• Memory: 256 MB (recommended)
• Hard Disk space: 2 GB hard disk with 1.5 GB available hard-
disk space
• Internet Explorer 5.5 or later, or Mozilla 1.0

Installing software

Insert the supplied CD-ROM into your CD-ROM drive.
1
The CD-ROM will automatically run. If it does not, click
Start Run, enter x:/cdsetup.exe (x represents your
CD-ROM drive), and click OK.
Select the language you want.
2
Click Typical installation for a network printer.
3
Follow the onscreen instructions to complete installation.
4
Click Finish when installation is done.
5

Uninstalling software

You should remove the Network utilities if you are upgrading
the software or if the installation fails.
Note : Close all programs before uninstalling software.
Click Start Programs
1
Uninstall SetIP.
Click OK to confirm uninstallation.
2
Click Finish when uninstallation is done.
3
Type 104 SetIP
2.1

Programs supplied on the CD

IP address setup

Before using your network print server in your network, you
must set TCP/IP addresses for the print server. You will need
your printer card's MAC address, IP address, subnet mask, and
gateway address. First, check with your network administrator
for the TCP/IP addresses.
: The MAC address is the hardware serial number of the
Note
network printer card. You can check the address by printing
the Network Printer Configuration Page. For printing the page,
refer to your printer user's guide.
You can set your print server's IP address via the following
methods:
• Printer control panel: If your printer has a control panel and
the network configuration menu, you can set the IP address
directly from the printer. Refer to your printer user's guide.
• SetIP program: Go to the Using SetIP.
• Web Image Monitor Type 104: Once you have set an IP
address for your network print server, you can use the
embedded web server in the network printer card to change
the address. Go to next column.
• DHCP: You can use Dynamic Host Configuration Protocol
(DHCP) to get an IP address automatically assigned by your
network administrator, if your network system supports this
protocol.
• BOOTP: A network-based server using the BootStrap
protocol (BOOTP) can notify the network printer card of its
assigned IP address each time the printer turns on, if your
network system supports this protocol.
: To get an IP address from the DHCP or BOOTP server,
Note
the IP assignment method must be set to DHCP or BOOTP.
Using SetIP
From the Windows Start menu, select Programs
1
104 SetIP SetIP.
The program automatically detects and displays new and
configured print servers on your network.
Type