Ricoh 3200SF - Multifunctional SP Network-Ready User Manual page 75

Message Meaning
Invalid Server The server address
Address you have entered is
invalid.
Line Busy The receiving fax
machine did not
answer or the line is
already engaged.
[Line Error] Your machine
cannot connect with
the receiving fax
machine or has lost
contact because of a
problem with the
phone line.
Low Heat Error There is a problem
Cycle Power in the fuser unit.
LSU Motor Error A problem has
Cycle Power occurred in the LSU
(Laser Scanning
Unit).
LSU Hsync Error A problem has
Cycle Power occurred in the LSU
(Laser Scanning
Unit).
Main Motor There is a problem
Locked in the main motor.
Mail Exceeds The mail size is
larger than the
Server Support
supported size by
SMTP server.
Memory Full The memory is full.
MP Tray There is no paper in
the multi-purpose
Paper Empty
tray.
Network Error There is a problem
with the network.
Suggested solutions
Enter the correct server
address.
Try again after a few
minutes.
Try again. If the problem
persists, wait an hour or
so for the line to clear
and try again.
Or, turn the ECM mode
on. See page 10.1.
Unplug the power cord
and plug it back in. If the
problem persists, please
call for service.
Unplug the power cord
and plug it back inches. If
the problem persists,
please call for service.
Unplug the power cord
and plug it back inches. If
the problem persists,
please call for service.
Open and then close the
front cover.
Divide your mail or
reduce the resolution.
Delete unnecessary fax
jobs and retransmit after
more memory becomes
available. Alternatively,
split the transmission into
more than one operation.
Load paper in the multi-
purpose tray. See page
5.7.
Contact your network
administrator.
14.8
Message Meaning
[No Answer] The receiving fax
machine has not
answered after
several redial
attempts.
Not Assigned The speed button or
speed dial number
you tried to use has
no number or email
address assigned to
it.
[No Paper] The paper in the tray
Add Paper has run out.
One Page is Single page data
exceeds the
Too Large
configured mail size.
Open Heat Error There is a problem
Cycle Power in the fuser unit.
Operation Not You are in the Add
Assigned Page/Cancel Job
operation, but there
are no jobs stored.
Over Heat Error There is a problem
Cycle Power in the fuser unit.
Paper Jam 0 Paper has jammed
Open/Close Door in the feeding area
of the tray.
Paper Jam 1 Paper has jammed
Open/Close Door in the fuser area.
Paper Jam 2 Paper has jammed
Check Inside in the paper exit
area.
Power Failure Power has turned off
then on and the
machine's memory
has not been back
up.
<Troubleshooting>
Suggested solutions
Try again. Make sure that
the receiving machine is
operational.
Enter the number or
email address manually
using the number keypad
or store the number or
address.
Load paper in the tray.
See page 5.5.
Reduce the resolution
and try again.
Unplug the power cord
and plug it back in. If the
problem persists, please
call for service.
Check the display to see
if there are any
scheduled jobs.
Unplug the power cord
and plug it back in. If the
problem persists, please
call for service.
Clear the jam. See page
14.2 and page 14.3.
Clear the jam. See page
14.3.
Clear the jam. See page
14.4.
The job which you were
trying to do before the
power failure must be
completely re-done.