Sampler - DigiTech RP12 Owner's Manual

Guitar signal processor/ foot controller and preamp
Table of Contents

Advertisement

RP-12 Owner's Manual

Sampler

out of the turnaround points. TRIANGLE is a
linear modulation effect, and ramps the pitch
of the wave up and down with no slowing at
turnaround points. LOGARITHMIC and EXPO-
NENTIAL waveforms are more dramatic in
their effect on the signal, producing a type of
bouncy oscillation. This Parameter appears
only in Modulated Delays.
The RP-12 offers a studio-grade sampler Module for maximum flexibili-
ty and usefulness. It uses a 40 kHz sample rate for increased sound
quality. Sample recording and playback can be triggered from the RP-
12 pedalboard, or via MIDI (through continuous controller linkages).
Sample recording can also be triggered upon detection of a sound
source. Parameters of sampler Modules are as follows:
Sampler On / Off ...........Turns the Module on or off.
Smpl Plybck Levl...........Determines the overall level of the sample
when played back. Varies from 0 to 100.
Smpl Looping ................This Parameter has two settings: MANUAL
and AUTO. When this Parameter is set to
MANUAL: the sample must be triggered either
manually or using an audio trigger. When the
sample is finished playing, it resets and waits
for another manual trigger. When this
Parameter is set to AUTO, the sample begins
playing. When the sample is finished playing, it
is automatically retriggered from the beginning
of the sample, and continues retriggering until
the Parameter is switched back to MANUAL.
Smpl Record/Play .........Sets the mode of operation for the sampler
Module. When set to RECORD, the sampler
will record a new sample into memory when
triggered. This parameter automatically
changes to PLAYBACK after the sample in
memory has been recorded.
NOTE: Samples can not be stored.
Manual Trigger ..............This Parameter allows manual playback trig-
gering of the sample in memory. To trigger the
sample, simply press the <UP> Parameter but-
ton on this screen. To trigger the Sampler
using MIDI, link this Parameter to a MIDI CC
number (see Assigning CC links, pg. 59).
Smpl Triggr Mode..........Determines whether audio triggering or manu-
33
Section 4 - Effects and Parameters

Advertisement

Table of Contents
loading

Table of Contents