Table of Contents
Advertisement
62
Section 8 - MIDI Set-Up
NOTE: The MINIMUM CC VALUE and MAXIMUM CC VALUE
Parameters allow you to limit the range of the continuous controllers in
the full on and full off positions. The values you select on these two
screens determine the behavior of the continuous controller. For exam-
ple, if a Parameter ranges from 0-100 and MINIMUM CC VALUE is set
at 40, the lowest the Parameter can go to via continuous control is 40.
Likewise, if MAXIMUM CC VALUE is set at 90, the CC range would
run from 40 to 90. It is also possible to set MINIMUM CC VALUE high-
er than MAXIMUM CC VALUE to reverse the action (polarity) of the
continuous controller.
• Use the <UP/DOWN> Parameter buttons to set the minimum
Parameter value when the CC pedal is at minimum.
• Press the <RIGHT> Parameter button once. The display reads:
Maximum CC Value
≤[PARAM VALUE]
The number shown with this Parameter automatically defaults to
the maximum Parameter value.
• Use the <UP/DOWN> Parameter buttons to set the maximum
Parameter value when the CC pedal is at maximum travel range.
• Press the <MIDI> button once to return to the Parameter screen.
Note that the CC symbol appears in the upper right corner of the
display. This symbol simply tells you that the Parameter is linked
to a continuous controller.
At this point, you have successfully linked a CC # to control a
Parameter. When you move your CC transmitting device (such as the
CC Pedal of the Pedalboard), the RP-12 sweeps smoothly between
the two values you selected (MINIMUM CC VALUE, MAXIMUM CC
VALUE). The Program must now be saved or the CC Link assignment
will be lost upon changing Programs (see Storing/Naming Programs,
pg. 21).
NOTE: In order for the RP-12 to respond to incoming CCs, the RP-
12 MIDI channel setting must correspond with the channel desig-
nation of the incoming messages. The RP-12 MIDI channel can be
set to any one of the 16 MIDI channels, or all channels (omni).
Refer to MIDI Channel on pg 58.
Let's go back to the CC LINK screen for a moment and tackle another
scenario: if the Local Link number you want already has a CC assign-
ment, the CC LINK display will read:
RP-12 Owner's Manual
Advertisement
Table of Contents
