Duckers; Phase Inverter - DigiTech RP12 Owner's Manual

44

Duckers

Phase Inverter

Section 4 - Effects and Parameters
Level..............................Controls the overall level of the wah effect.
Varies from 0 to 100.
Wah Pedal Position.......The PEDAL POSITION Parameter reflects the
current setting of the continuous control device
used to control the wah effect. This Parameter
can be modified using the RP-12's pedal to
perform the wah function. As the Parameter is
modified, the tone of the original note will
change. Varies from 0 to 127.
This effect lowers the level of an Effect passing through the ducker
when a signal is present at the third input. This allows the effect pass-
ing through the ducker to be more dynamic.
Effect On / Off ...............Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Duc Threshold ...............Sets the minimum input level required to trig-
ger the ducker (it is perhaps easier to think of
this Parameter as the ducker sensitivity).
Higher settings of DUC THRESHOLD require
higher input levels to trigger the ducker.
Lower settings make the ducking effect easier
to trigger. Ranges in 1 dB steps from -100 to
0 dB.
Duc Hold Time ..............Controls the amount of time before the ducker
disengages after the signal has stopped.
Varies from 0.000 to 5.000 seconds.
Duc Attenuation.............Adjusts the amount of level attenuation applied
to the ducked effects when the ducker is
engaged (ducker is engaged when the input
level exceeds the setting of CONTROL
THRESHOLD). Adjustable from -100 dB to 0
dB.
Duc Attack Rate ............Sets the amount of time over which the ducker
will reach full attenuation. Adjustable in mil-
liseconds from 0.00 to 5.00 seconds.
Duc Release Rate .........Sets the amount of time over which the ducker
will disengage. Adjustable in milliseconds from
0.00 to 5.00 seconds.
Phase Inverter ...............Flips the signal phase 180 degrees. Settings
are either IN PHASE or OUT OF PHASE.
RP-12 Owner's Manual