Prglist Assign; List Size; Steps - DigiTech RP12 Owner's Manual

Guitar signal processor/ foot controller and preamp
Table of Contents

Advertisement

52

PrgList Assign

Section 6 - Pedalboard Set-Up
¡Assign CC Pedal
™Calibrate Pedal
• Press Function button <MIX
Set Pedal Down
(Forward) press¡
• Move the pedal to its full forward (toe down) position, and press
Function button <MOD
Set Pedal Up
(Back), press ™
• Move the pedal to its full back (toe up) position, and press
Function button <MIX
setup menu, you have successfully calibrated the CC pedal.
This section explains the procedure of how to assign a List Size and
assigning Program numbers to step numbers of the List.
• From Program mode, press the <UTILITY> button once.
• Press the Function button <MOD
¡Pedals
™CC Ped
£PrgList Assign≥
• Press Function button <MORE

List Size:10

•Press the <UP> and <DOWN> Parameter buttons to select the list
size you want. The list is set to be 10 steps long from the factory.
However, you can assign up to 32 steps in a list.
•From the above screen press the <RIGHT> Parameter button.
The display reads:
¡Step Number
≤™[PROG NAME]
The cursor should be under the Step number on the above screen. At
this point, each time you press the <UP> and <DOWN> Parameter
RP-12 Owner's Manual
>. The display reads:
¡
>. The display reads:
>. When the display returns to the Utility
¡
> once. The display reads:
£
>. The display reads:
1
#

Advertisement

Table of Contents
loading

Table of Contents