Installation Location; Installation Environment - Xerox DocuColor DocuColor 4 Setup Manual

1.1
For safe and convenient printer/copier operation, consider the following when
determining the installation location.
1
1.1.1

Installation Environment

Install the printer/copier in a location meeting the following con-
ditions:
If the printer/copier is located in a cold room that is rapidly heated, or if the
printer/copier is moved from a cold place to a warm humid place, condensa-
tion may occur within the printer/copier, degrading print quality. If this oc-
curs, allow the printer/copier to adapt to the environment for about one hour
before use.
Connect the Printer/Copier to its own outlet.
If at all possible, the power outlet for the printer/copier should be exclu-
sively dedicated to it. If the printer/copier is connected to the same circuit
used by other high-current machines, such as another copier or air condi-
tioner, or to an electrically noisy machine, low voltage or noise may cause
computing errors resulting in data loss and improper performance.
Connect the power plug to an outlet with the same rated voltage as the printer/
copier (115-240V), and fused for at least 15 Amperes for 115V and 8 Amperes
for 220-240V. No other devices should be connected to this outlet, as over-
heating could cause fire or electric shock.
Avoid installing the printer/copier in the following locations:
2

Installation Location

On a level, stable surface.
In a well-ventilated location.
Ambient temperature range 5 to 32°C/41-89.6°F, Relative humidity 15 to
85% (non-condensating).
If the ambient temperature is 89.6°F, relative humidity should be main-
tained below 48%. If the relative humidity is 85%, the ambient tempera-
ture should maintained below 82.4°F.
Where it is exposed to direct sunlight.
Near an air condition or heater.
Where wind could blow upon it.
Where it might be subject to vibration.
In a dusty place.