Testing A Pen - Wacom CINTIQ 21UX DTK-2100 Installation Manual

TESTING A PEN

1. While observing the P
display screen. A value for P
number) should be displayed. If you have more than one Cintiq unit connected to your system, be
sure you have selected the unit for which you are testing a pen in the T
2. Move your tool along the pen display screen surface. The X and Y D
reflect the tool position.
3. Test your pen switches. The Cintiq status LED should light blue each time you click with the tool
tip, press the side switch, or press the tool eraser to the display screen.
• Press on the display screen surface with the tool tip. The S
should change. (P
approximately 100% when full pressure is applied.)
• Next, press the side switch without pressing the tip to the tablet. The S
change. (For the Grip Pen, do this for both positions of the DuoSwitch.)
Pen
Airbrush
• Press the tool's eraser to the display screen. The S
change. (P
RESSURE
approximately 100% when full pressure is applied.)
• For the optional Airbrush, move the fingerwheel forward. The W
value of approximately 0 when the fingerwheel is all the way forward. Move the fingerwheel
backward. The W
the way back.
4. Test tilt for the x-axis by moving the pen from a vertical position toward the right; the X T
should change from approximately 0 to +60. Now move the tool to the left of vertical; the X T
value should change from approximately 0 to - 60.
5. Test the tilt for the y-axis by moving the pen from a vertical position toward the bottom of the
tablet; the Y T
ILT
the top of the tablet; the Y T
6. For the optional Art Pen, test the rotation feature by placing the pen tip on the display screen
surface and slowing rotating the pen on its axis. The R
the pen.
7. When you are done, click on the C
Troubleshooting
Page 46
D I
OINTING EVICE NFO
, the D
ROXIMITY
should change from approximately 0% with no pressure applied to
RESSURE
Tip = 1, DuoSwitch (lower position) = 2, DuoSwitch (upper position) = 3,
Eraser = 1
Tip = 1, Side switch = 2, Eraser = 1
should change from approximately 0% with no pressure applied to
value should increase to approximately 1000 when the fingerwheel is all
HEEL
value should change from approximately 0 to +60. Now move the tool toward
value should change from approximately 0 to - 60.
ILT
LOSE
column, bring your pen within 5 mm (0.2 inch) of the
N , D
EVICE AME EVICE
state and P
WITCHES
OTATION
button to exit the dialog box.
T , and a D S/N (serial
YPE EVICE
I column.
ABLET NFO
values should change to
ATA
state and P
WITCHES RESSURE
WITCHES
value should
RESSURE
value should decrease to a
HEEL
value should change as you rotate
value
state should
value
ILT
ILT