Testing The Touch Strips - Wacom CINTIQ 21UX DTK-2100 Installation Manual

TESTING THE TOUCH STRIPS

1. With the D
IAGNOSTICS
Strip. If you have more than one Cintiq unit connected to your system, be sure you have selected
the unit you are testing from the T
2. Slide your finger up or down along the entire length of the Touch Strip you want to test. As you
touch and move your finger along the Touch Strip, a number will indicate the current finger
position for the respective Touch Strip next to L
3. Press the corresponding Touch Toggle button for the Touch Strip you are testing. This will toggle
between the four customizable states of the Touch Strip. As you cycle between settings, a
corresponding LED should illuminate. Within the D
also be shown.
If any of the functions are set to S
sequence.
4. When you are done, click the C
Important: Remember that some applications can override and control the Touch Strip functions.
Consider closing any open applications except the Wacom Tablet control panel when testing
the Touch Strips.
dialog box open, observe the T
I
ABLET NFO
, the corresponding LED will be skipped in the toggle
KIP
button to exit the dialog box.
LOSE
I column as you test each Touch
ABLET NFO
column.
T S or R
EFT OUCH TRIP
dialog box, the button state should
IAGNOSTICS
T S .
IGHT OUCH TRIP
Troubleshooting
Page 45