Setting The Still Image Size - Toshiba Gigashot GSC-R60 Owner's Manual

Setting the Still Image Size

1
From the recording menu, use the jog dial to select [STILL
IMAGE SIZE] and press the OK button.
■ RECORDING MENU
CONTINUOUS RECORDING
VIDEO QUALITY
STILL IMAGE SIZE
WHITE BALANCE
ISO SENSITIVITY
EXIT
2
Use the jog dial to select the image size and press the OK
button.
STILL IMAGE SIZE
When you select [SHQ(WIDE)], [HQ(WIDE)] or [SP(WIDE)] as the video quality, the
still image sizes are as follows:
: 1600 ✕ 900 pixels
2M
1.2M : 1280 ✕ 720 pixels
0.3M : 640 ✕ 360 pixels
Approximate Number of Available Shots for Still Images
The table below shows the approximate number of still images that may be stored
on to the camera's hard disk drive and SD cards. Because the amount of data used
varies depending on the size of each image, the number of storable images listed
below is approximate and may vary.
Still image
size
(GSC-R60)
2M
1.2M
0.3M
* 1GB= 1 billion bytes. The actual formatted capacity may be lower than the figure shown
here.
The available image sizes are displayed along with the
number of available shots for each size.
1.2
M
The selected image size is set and the recording menu
reappears.
To cancel the setting, press the MENU button.
2M
2974
2M
1.2M : 1280 ✕ 960 pixels
CANCEL
0.3M : 640 ✕ 480 pixels
Hard disk drive
60GB* 30GB
(GSC-R30)
32,000 30,508
32,000 32,000
32,000 32,000
: 1600 ✕ 1200 pixels
2GB 1GB
2,056 1,036
3,427 1,728
10,282 5,184
SD card
512MB 256MB
515 237
859 396
2,578 1,189
128MB
119
199
599