Table 28 Advanced Application > Broadcast Storm Control - ZyXEL Communications Dimension GS-2024 User Manual

Chapter 12 Broadcast Storm Control
The following table describes the labels in this screen.
Table 28 Advanced Application > Broadcast Storm Control
LABEL
Active
Storm Control
Type
Packet Limit
Port
*
Active
Apply
Cancel
108
DESCRIPTION
Select this check box to enable traffic storm control on the Switch. Clear this check
box to disable this feature.
Select the type(s) of packets you want to control. You can select Broadcast only;
Broadcast and multicast; Broadcast and unknown unicast; or Broadcast,
multicast, and unknown unicast.
Select the maximum number of packets of the specified type(s) that the Switch
accepts each second.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this to control the specified type(s) of packets on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
GS-2024 User's Guide