Figure 92 Ip Application > Dhcp > Vlan; Table 60 Ip Application > Dhcp > Vlan - ZyXEL Communications Dimension GS-2024 User Manual

You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch. See
information on how to do this.
Figure 92 IP Application > DHCP > VLAN
The following table describes the labels in this screen.
Table 60 IP Application > DHCP > VLAN
LABEL
VID
Remote DHCP
Server 1 .. 3
Relay Agent
Information
Information
Add
Cancel
Clear
VID
Type
DHCP Status
GS-2024 User's Guide
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Enter the IP address of a DHCP server in dotted decimal notation.
Select the Option 82 check box to have the Switch add information (slot number, port
number and VLAN ID) to client DHCP requests that it relays to a DHCP server.
This read-only field displays the system name you configure in the General Setup
screen.
Select the check box for the Switch to add the system name to the client DHCP
requests that it relays to a DHCP server.
Click Add to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Click this to clear the fields above.
This field displays the ID number of the VLAN group to which this DHCP settings
apply.
This field displays Relay for the DHCP mode.
This field displays the first remote DHCP server IP address.
Chapter 23 DHCP
Section 7.6 on page 69 for
171