Setting Remote Control Codes - Yamaha RX-V765 Owner's Manual

Playback
Registering input source/sound field
program
Select the! desired input source/sound field
program, and press down @SCENE (or
rnJSCENE:) until "SET Complete" appears on the
front panE!1 display.
When the OSD is displayed on the video monitor,
"SCENE Setting Complete" appears on the video monitor.
You can adjust the balance of the high frequency range
(Treble) and low frequency range (Bass) of sounds output
from the front left and right speakers to obtain desired
tone.
,',
~<i>~
• The tone control of the speakers or headphones can be set separately. Set
the headphone lOne control with the headphones connected.
:-'(,{~
• If you are using the remote conlrol for an external component. set that
external component too whenever SCENE setting is performed. For more
details. see Ihe next section.
Switching remotely controlled external
components linked to SCENE selections
1
Press @TONE CONTROL on the front panel
repeatedly to select "Treble" or "Bass."
The current setting is displayed on the front panel
display.
•
Rotate the @PROGRAM selector to adjust
the output level in those frequency ranges.
Adjustable range:
-10.0
dB to
+10.0
dB
The display returns to the previous screen soon after
you release the selector.
~\~/-:.
• The front panel display lurns off in Pure Direct mode. It turns on again
when Pure Direct mode is turned otf.
Use Pure Direct mode to enjoy the pure high fidelity
sound of the selected source. When Pure Direct mode is
activated, this unit plays back the selected source with the
least circuitry.
Press @PURE DIRECT (or [IDPURE DIRECT)
to turn the Pure Direct mode on or off.
The following features are disabled in Pure Direct mode.
- sound field program and tone control
- display and operation of the OPTION menu and
SETUP menu
- multi-zone function
Notes
2
• The lone control setlings are not effective during playback in Pure Direct
mode.
• If you set the balance extremely off. sounds may not match those from
other channels well.
1
Register the remote control code of an
external component to the desired input
source (see page 62).
Note
2
Press [ll]MUTE again to resume audio
output.
• Remote control codes cannot be registered to TUNER, SIRIUS, or
XM inpul sources.
2
Press [§]Input selection keys on the
remote control for the input source whose
remote control code was registered in step 1
for about 3 seconds while pressing down
rnJSCIENE key whose assignment you want
to change.
The external component can now be controlled
remotely just by selecting the
rnJSCENE
key.
1
Press [ll]MUTE on the remote control to mute
the audio output.
The MUTE indicator on the front panel display
flashes while audio output is muted.
You can operate an external component with the remote
control of this unit by setting a remote control code for the
external component for each input source. Setting remote
control codes for desired input sources allows you to
switch between external components linked to SCENE
selections.
When you change the SCENE key settings, change
settings of the external component as well by following
the steps below.
25
En