Yamaha RX-V765 Owner's Manual page 66

You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to "List of remote
control codes" at the end of this manual.
.:-\cil~
• Each of the steps described in this section should be performed within
one minute. Setting operation is automatically canceled when one minute
has passed since the last step. If the operation is cancelled, start again
from the beginning.
1
Press !lIDCODE SET on the remote control
using a pointed object such as the tip of a
ballpoint pen.
ffi]TRANSMIT on the remote control blinks twice.
2
Press [§Jlnput selection keys
corresponding to the input source whose
rem01te control code you want to register.
3
Enter a remote control code using
!liINumeric keys.
Once the remote control code is registered,
ffi]TRANSMIT on the remote control blinks twice.
If it fails, ffi]TRANSMIT blinks six times. Repeat
from step I.
Controlling other components with the remote control
You can clear all the remote control codes previously set,
and reset all of them
to
the initial factory settings.
,:oW,:
• Each of the steps described in this section should be performed within
one minute. Setting operation is automatically canceled when one minute
has passed since the last step. If the operation is cancelled. start again
from the beginning.
1
Press !lIDCODE SET on the remote control
using a pointed object such as a tip of a
ballpoint pen.
ffi]TRANSMIT on the remote control blinks twice.
2
Press [Q]SETUP on the remote control.
3
Enter "9981" using !liINumeric keys.
Once the initialization is complete, ffi]TRANSMIT
on the remote control blinks twice. If it fails,
ffi]TRANSMIT blinks six times. Repeat from
step I.
63
En
•