Yamaha RX-V765 Owner's Manual page 77

Troubleshooting
Problem
Se.:;r·ch
in':::! •••
Canceled
t·jot fOI_md
Cause
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of the pairing.
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of establishing the connection.
The pairing is completed.
The pairing is canceled.
The connection between the Yamaha
Bluetooth wireless audio receiver and the
Bluetooth component is established.
The Bluetooth component is disconnected
from the Yamaha Bluetooth wireless
audio receiver.
The Bluetooth component is not found.
Remedy
During pairing:
- pairing must be performed on the Bluetooth
component and this unit simultaneously. Check if
the Bluetooth component is in pairing mode.
During connecting:
- check if the Bluetooth component is turned on.
-check if the Bluetooth component is within 10 m
of the Yamaha Bluetooth wireless audio receiver.
See
page
Notes
• If an error or warning message is displayed, resolve the problem and run the automatic setup procedure again.
• Warning message "W-2"' or
"w-r
indicates that the adjusted settings may not be optimal.
• Depending on the speakers, warning message "W-]" may appears even if the speaker connections are correcl.
• If error message "E-I 0" occurs repeatedly, contact a qualified Yamaha service center.
Before Auto Setup
Error message
Connect.. tHC
I
UnF
1
U':::!
HF'
I
During Auto Setup
Error message
E-l: tm FF.:otn SF'
E-2: tJD SUF.:. SF'
74
En
Cause
Optimizer microphone is not connected.
Headphones are connected.
The parameters of this unit are protected.
Cause
Front LlR channel signals are not
detected.
Only one surround channel signal is
detected.
Remedy
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Set "Memory Guard'- to "Off."
Remedy
Check the front LlR speaker connections.
Check the surround LlR speaker connections.
See
page
21
59
See
page
II
II