Yamaha RX-V765 Owner's Manual page 76

Troubleshooting
Problem Cause Remedy
See
page
External components
cannot be controlled
by the remote control.
The remote control code is not correctly
set.
Set the remote control code correctly using "List of
remote control codes" at the end of this manual.
Try setting another code of the same manufacturer
using "List of remote control codes" at the end of this
manual.
63
63
If this unit does not work when you press
IDJCursor.
do the following.
When the key does not work during DVD disc menu
operation: press the ffiJlnput selection keys on
the remote control again.
When the key does not work during OPTION menu/
SETUP menu operation: press the key applicable for
the current menu operation again.
Even if the remote control code is
correctly set. there are some models that
do not respond to the remote control.
Note
• In case of a transmission error without a status message appearing on the front panel display and on the 050. check the connection of your iPod
(see page 19:1.
Problem
Cause Remedy
See
page
Connect an iPod supported by this unit.
19
Remove your iPod in the Yamaha iPod universal dock 19
and then place it back in the dock.
Check that the songs currently stored on your iPod
are playable.
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK jack of this unit.
Your iPod is properly placed in the
Yamaha iPod universal dock.
Your iPod is removed from the Yamaha
iPod universal dock.
This unit cannot play back the songs
currently stored on your iPod.
The iPod being used is not supported by
this unit.
There is a problem with the signal path
from your iPod to this unit.
This unit is in the middle of acquiring
song lists from your iPod.
This unit is in the middle of recognizing
the connection with your iPod.
iPod Connect.ed
D i
:=.(.(Innec
t.ed
Un."b 1 e t.o
p
1,,,'0'
Connect E;.r·r·or·
Loadin'OI. , .
I
73
En