Dell PowerEdge E05S Owner's Manual page 40

Message
Alert! System
fatal error
during previous
boot.
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
BIOS Update
Attempt Failed!
Caution!
NVRAM_CLR jumper
is installed on
system board.
CPU set to
minimum
frequency.
40
About Your System
Causes
An error caused the system to
reboot.
System is in manufacturing
mode.
Remote BIOS update
attempt failed.
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.
The processor speed may be
intentionally set lower for
power conservation.
Corrective Actions
Check other system
messages for additional
information for possible
causes.
Reboot to take the system
out of manufacturing mode.
Retry the BIOS update. If
the problem persists, see
"Getting Help" on page 185.
Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 53.
If not an intentional setting,
check any other system
messages for possible causes.