Floppy Drive - Dell Precision YT583 User Manual

4 Replace the computer cover (see "Replacing the Computer Cover" on
page 145).
See the documentation that came with the drive for instructions on
installing any software required for drive operation.

Floppy Drive

CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before opening the cover.
NOTICE:
To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer's electronic
components. You can do so by touching an unpainted metal surface on the
computer.
NOTE:
A floppy drive or Media Card Reader must be installed in the 3.5-inch drive
carrier in order to be installed in a drive bay.
Removing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 139.
CAUTION:
Your computer is heavy (it has an approximate minimum weight of 55
lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid
injury; avoid bending over while lifting. See your
other important safety information.
CAUTION:
The computer stand should be installed at all times to ensure
maximum system stability. Failure to install the stand could result in the computer
tipping over, potentially resulting in bodily injury or damage to the computer.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 141).
3 Remove the drive panel (see "Removing the Drive Panel" on page 246).
4 Disconnect the power and data cables from the back of the floppy drive.
5 Disconnect the other end of the drive cable from the system board
connector labeled "DSKT." To locate system board connectors, see "System
Board Components" on page 27.
Product Information Guide
Adding and Replacing Parts
.
Product Information Guide
for
251