Dell Precision YT583 User Manual page 268

Installing an Optical Drive
1 Follow the procedures in "Before You Begin" on page 139.
CAUTION:
lbs) and can be difficult to maneuver. Seek assistance before attempting to lift,
move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid
injury; avoid bending over while lifting. See your
other important safety information.
CAUTION:
maximum system stability. Failure to install the stand could result in the computer
tipping over, potentially resulting in bodily injury or damage to the computer.
2 If you are installing a new drive, unpack the drive and prepare it for
installation.
Check the documentation that accompanied the drive to verify that the
drive is configured for your computer.
3 Remove the computer cover (see "Removing the Computer Cover" on
page 141).
4 Remove the drive panel (see "Removing the Drive Panel" on page 246).
5 If another device is installed in the optical drive bay, remove that device
(see the appropriate instructions in this section).
6 If the optical drive bay is unpopulated, remove the drive panel insert (see
"Removing a Drive-Panel Insert" on page 247).
7 If no screws are attached to the drive, check the inside of the drive panel
for screws, and attach screws to the new drive.
268
Adding and Replacing Parts
Your computer is heavy (it has an approximate minimum weight of 55
The computer stand should be installed at all times to ensure
Product Information Guide
for