4
52
To increase damping: Use the
tool from the on-board tool-
kit to turn the adjusting screw
z
or the adjusting ring, as ap-
plicable, in the appropriate dir-
ection so that mark 3 or, re-
spectively, 4 points to a higher
reading on the scale.
To reduce damping: Use the
tool from the on-board tool-
kit to turn the adjusting screw
or the adjusting ring, as ap-
plicable, in the appropriate dir-
ection so that mark 3 or, re-
spectively, 4 points to a lower
reading on the scale.
Compression stage, basic
setting, rear, high speed
Position 2 (comfortable set-
ting with rider 85 kg)
Position 6 (normal setting
with rider 85 kg)
Position 10 (sports setting
with rider 85 kg)
Compression stage, basic
setting, rear, low speed
Position 1 (comfortable set-
ting with rider 85 kg)
Position 4 (normal setting
with rider 85 kg)
Position 9 (sports setting
with rider 85 kg)
Adjusting rebound-stage
damping for rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Adjust compression-stage
damping by turning adjusting
screw 1.
To increase damping: Use the
tool from the on-board kit to
turn the adjusting screw in the
appropriate direction so that